DramaiLanguage: EspañolGet Dramai Pro

Auditions and self-tapes

How to self-tape an audition: a step-by-step guide

Dramai · Updated:

A self-tape is the scene video you record yourself for an audition, and a phone is enough to film it. A good self-tape does not need expensive equipment: a phone that stays still, soft light on your face, a quiet room, a plain background and someone to read the other lines. The rest is preparation: having worked the scene before you press record.

This article covers the filming side, step by step. If the instructions you were sent contradict anything here, follow the instructions; on framing, length, file names and the like, the casting team has the last word.

Read the instructions first

A self-tape request usually tells you which scenes to film, whether to shoot landscape or portrait, whether a slate is wanted (a short introduction to camera), how to name the file, and where and by when to send it. Read the instructions once from top to bottom, then write the points down on paper. The most common self-tape mistake has nothing to do with acting; it is a skipped instruction.

Where the instructions are silent, the habits below are a safe default.

Room and background

  • Choose a quiet room. A fridge, traffic, a television next door: all of them are louder on the recording than you expect. Record ten seconds of silence before you start and listen back.
  • Simplify the background. A plain wall in one color is enough. Take pictures, shelves and door handles out of frame. Do not stand flat against the wall; take a step or two forward so your shadow does not fall on it.
  • Dress for the scene, but simply. You do not need a costume. Small patterns and shiny lettering flicker on camera; solid colors are easier to watch.

Framing

  • Fix the phone in place. No tripod? A stack of books does the job. Do not film handheld.
  • Shoot landscape unless the instructions say otherwise.
  • Put the camera at eye level. A camera that looks up or down at you changes your face.
  • Frame from mid-chest to just above your head, with a little space above it. If the scene needs movement, widen the frame a little, but not so far that your face stops being readable.
  • On most phones the rear camera gives a sharper picture than the front one. If you use it, check the frame first with a helper or a short test recording.

Light

One aim: your face, and above all your eyes, should be clearly visible.

  • Light from the front. The easiest source is a window in daytime: face the window and put the phone between you and it.
  • Do not put the window behind you. Light from behind turns your face dark.
  • If you film in the evening, place two lamps either side of your face, a little above eye level. A single ceiling light throws shadows into your eye sockets.
  • Keep the light the same through the take. On a cloudy day window light shifts within minutes; finish the scene in one lighting condition.

Sound

A flaw in the picture is forgiven; a line nobody can make out is not.

  • In a quiet room without echo, the phone’s own microphone is usually enough. Soft surfaces such as rugs, curtains and sofas reduce echo.
  • Do not stand too far from the phone. If your voice sounds distant, tighten the frame or use a clip-on microphone if you have one.
  • Film a short test and listen on headphones. Check the balance between your voice and your reader’s.

Who reads the other lines?

During filming, the person reading the other lines stands right beside the camera. They do not need to be an actor; calm, even reading is enough.

  • Keep your eyeline on the reader, not on the camera. If the reader stands right next to the lens, your face stays open to the camera. Do not look into the lens unless the instructions ask for it.
  • The reader should not be louder than you. Standing closer to the phone, their voice dominates the recording; ask them to read a little more quietly.
  • If nobody is with you, a friend can read over a phone or video call. In that case, try to take their voice through an earphone rather than a speaker so that it stays off the recording, and always listen to the result.

Having prepared the scene before filming day, rather than working with your reader for the first time on the day, makes the shoot shorter.

Filming

  1. If a slate is wanted, film it separately. It is usually your name and the few details the instructions ask for. Say what is asked, briefly and simply.
  2. Film the scene from start to finish without cutting. Do not edit; add no music, effects or captions unless the instructions ask.
  3. Do few takes. After three or four attempts the take usually stops getting better and only gets different. Change one thing between takes: the pace, the intention or a pause.
  4. When choosing, watch once with the sound off and listen once with your eyes closed. The first shows whether your face and eyeline read; the second, whether your lines are clear.

Checklist before you send

  • Have you filmed every scene in the instructions?
  • Is the picture landscape and steady, and is your face well lit?
  • Can the lines be understood without headphones, on a phone speaker?
  • Do the file name, format and length match the instructions?
  • If you are sending a link, does it open on another device?
  • Are you sending it before the deadline?

Before you film: prepare the scene

Everything above is the technical side, and once it is set up you reuse it. What carries a self-tape is the scene itself: knowing what your character wants, saying the lines with ease, really listening to the other line. The way there is to prepare for the audition and to run the scene out loud, with the other lines, several times before you film.